Maintain the PrismPlus
f. Install the take-up roller in the PrismPlus and press down firmly until the take-up roller
snaps into place.
- Important! Do not roll the STOP - Wind Leader Onto Take-up Core Stopping here
marking on the Ribbon Leader onto the take-up roller. The marking should not be past
the point shown in the picture on page 16. If the marking is on the roller, pull the take-up
roller out and roll back the ribbon. To take up the slack, roll the supply roller back.
4. To close the tray, press the operator button.
Note: During the ribbon validation process, the ribbon cycles past the ribbon leader. After
on is tight.
the ribbon validation process, ensure that the ribb
5. Install the top cover. The PrismPlus is ready for use.
110635_G 17