
FRRVCB40_60_08EM1.qxd:8804_8806_07EM1.qxd 10/16/08 8:58 AM Page 5
KNOW YOUR ICE CREAM MAKER
MAKER SIZE
•MOTOR DRIVE
Top mounted. Engages stem of DASHER and locks to bucket.
•COVER
Tab in COVER fits notch in ice cream can.
•DASHER
Stem on top fits through hole in center of COVER, and engages MOTOR DRIVE.
MOTOR DRIVE
COVER
DASHER
ICE CREAM CAN
For best results use Rival Rock Salt | 4 Quart | 6 Quart | |
| |||
ROCK SALT for making ice cream | 3 Cups | 4 Cups | |
ROCK SALT for hardening ice cream | 2 Cups | 3 Cups | |
|
|
| |
CRUSHED ICE for making and hardening ice cream | |||
|
|
|
4. | Place filled ICE CREAM CAN in BUCKET. Make sure ICE CREAM CAN is |
| centered and engages with bottom of BUCKET. |
5. | Place MOTOR DRIVE over ICE CREAM CAN so that stem of DASHER |
| engages hole in bottom of MOTOR DRIVE. Rotate ICE CREAM CAN |
| slightly until MOTOR DRIVE engages ICE CREAM CAN COVER. Rotate |
•ICE CREAM CAN Container holds ice cream mixture.
•DRAIN HOLE
Allows salt water to flow freely out of BUCKET.
•BUCKET
BUCKET SLOTS
DRAIN HOLE BUCKET
| the motor counter clockwise to secure tabs underneath motor into the |
| bucket. Plug power cord into 120 volt AC outlet. |
6. | While ice cream maker is running, distribute 2 inches of ice around |
| bottom of BUCKET. Sprinkle approximately 1/4 cup salt uniformly over |
| layer of ice. (See “Important points”) NOTE: The DASHER does not |
| move, the ICE CREAM CAN turns around it. |
7. | Continue adding layers of ice, with salt between layers, until ice level |
| reaches top of rotating ICE CREAM CAN. NOTE: Should ice cream |
MOTOR DRIVE tabs secure BUCKET. DRAIN HOLE located near top of BUCKET. Holds rock salt and ice.
HOW TO USE YOUR ICE CREAM MAKER
NOTE: Before using for the first time, wash all parts except MOTOR DRIVE (see “HOW TO CLEAN YOUR ICE CREAM MAKER”).
1.Pour chilled ice cream mixture into cooled ICE CREAM CAN. Fill ICE CREAM CAN only 3/4 full, as mixture will expand during freezing.
2.Insert DASHER. Be sure that bottom of DASHER fits the indentation at bottom of ICE CREAM CAN.
3.Place COVER on ICE CREAM CAN.
| maker stop before churning is complete (approximately |
| check to see if large ice cubes are jammed against the rotating ice |
| cream can. (See “Important Points”) |
8. | Ice cream should churn about |
| Unplug and remove MOTOR DRIVE. |
9. | Clear ice and salt away from top of ICE CREAM CAN. Wipe carefully to |
| remove salt and water before removing the COVER. Lift out DASHER |
| and scrape clean with a rubber spatula. Pack ice cream down into ICE |
| CREAM CAN. |