Rival IC500 warranty Operating Instructions, Frozen Drinks

IC500_ICM_IB.qx 6/8/07 11:22 AM Page 8

PARTS AND ASSEMBLY (CONT.)

OPERATING INSTRUCTIONS

4.Place the COVER over the front opening of the FREEZER CANISTER while keeping the RECIPE CHUTE at the top center of the COVER.

5.Align each of the three LOCKING CLIPS with each corresponding BRACKET on the FREEZER CANISTER. (See Fig.5)

6.Secure each LOCKING CLIP to the corresponding BRACKET and snap into place.

STEP 1: Place the end of the LOCKING CLIP over the farthest end of the BRACKET.

STEP 2: Pull the LOCKING CLIP forward until it locks into place. (See Fig.6)

NOTE: If preferred, the cover may be attached to the CANISTER (step 4-6) prior to attaching to BASE (step 3)

Fig.5 H

Fig.6	Step 2
	Step 1

NOTE:

•Wash and dry all parts, except BASE (See Cleaning and Maintenance).

•Rival® Icey Cream Machine must be on a level surface to function properly.

1.Place the FREEZER CANISTER in the freezer for at least 24 hours.

•Wash and dry canister thoroughly prior to freezing.

•Do not add ingredients until product is fully assembled and power switch is on.

2.Prepare one of the included recipes (See RECIPES), or use your own. Chilling the mixture beforehand is recommended.

CAUTION:

•Do not use the Rival® Icey Cream Machine to freeze liquids without any sugar (such as water or sugar-free beverages) as this may damage the appliance. Water will freeze very quickly to the interior of the FREEZER CANISTER and could damage the unit.

•Pour any alcohol desired into the unit during the last 3-5 minutes of freezing or dispense the drink first and add alcohol afterwards.

3.Take the frozen FREEZER CANISTER out of the freezer. Attach the MIXING PADDLE to the inside of the CANISTER, attach the CANISTER to the BASE, and secure the COVER (see assembly instructions).

NOTE: Do not add liquid until product is fully assembled and the power switch has been turned on.

I . Frozen Drinks

1.Plug the Rival® Icey Cream Machine into an electrical outlet and start the motor by turning the power switch to the ON position.

•Make sure the DISPENSING LEVER is in a fully upright position before turning the machine on or pouring in any liquid.

•Do not add liquid until the power switch has been turned on.

2.Carefully pour drink mixture into the RECIPE CHUTE. The liquid will flow into the FREEZER CANISTER and you will begin to see it rotating and freezing inside.

– 8 – – 9 –