Rival VS110 Replacing The Integrated Rolls, Replacing The Blade In Your Integrated Bag Cutter

Models: VS110

1 9
Download 9 pages 5.02 Kb
Page 5
Image 5
REPLACING THE INTEGRATED ROLLS

VS11003EM3 4/1/03 10:59 AM Page 8

REPLACING THE INTEGRATED ROLLS

1. The bag holder is spring-loaded. Place your hand on one end of the holder, using your other hand to push one end of the holder

into the other until it is no longer connected in the slot.

2. Pull open end of holder away from BAG ROLL CHAMBER, while simultaneously pulling the

holder out of the slot located on the opposite

end of the BAG ROLL CHAMBER. 3. Slide bags onto the holder.

4. Place one end of holder back into the slot

located within the BAG ROLL CHAMBER.

Note: Make sure bags are positioned to roll out from the bottom of the roll rather than the top.

5.Push in open end of holder so that it retracts into the other end.

6.Align the holder with the slot on the open end.

7.Release open end of holder until it connects into the open slot.

REPLACING THE BLADE IN YOUR INTEGRATED BAG CUTTER

1. Unscrew the three screws from the bottom panel.

2. Remove the bottom panel.

3. Replace the old knife blade with the new one.

4. Close the bottom panel.

5. Use screw driver to screw tightly the three screws.

CARE AND CLEANING

CLEANING THE FOOD SEALER

Always unplug the unit before cleaning.

Always remove from wall mounted position prior to cleaning.

Do not immerse in water.

Do not use abrasives to clean the unit.

Wipe the outside of the unit with a damp cloth and soap.

To clean the inside of the unit, wipe away any food or liquid with a paper towel.

Dry thoroughly before using again.

CLEANING THE REMOVABLE DRIP TRAY

The Seal-a-Meal®Vacuum Food Sealer is equipped with a REMOVABLE DRIP TRAY that allows you to thoroughly clean it between uses. When storing foods such as beef or chicken, juices tend to collect on the drip tray. Follow these simple instructions to do so:

Lift tab on one end of the REMOVABLE DRIP TRAY to release it from the drip tray compartment.

Note: Take care not to spill inside the drip tray compartment.

Clean the tray with soap and warm water.

Thoroughly dry the REMOVABLE DRIP TRAY prior to placing back into the drip tray compartment.

Align the center of the REMOVABLE DRIP TRAY with the vacuum port in the center of the drip tray compartment, so that the tab is on the right and the drip tray is beneath the NOZZLE.

Press down on the center until it is securely fastened in the drip tray compartment.

HINT: The REMOVABLE DRIP TRAY can be placed in the dishwasher for thorough cleaning if desired.

-8-

-9-

Page 5
Image 5
Rival VS110 manual Replacing The Integrated Rolls, Replacing The Blade In Your Integrated Bag Cutter, Care And Cleaning