![](/images/new-backgrounds/1108540/10854099x1.webp)
Setting the Basic System Information | RS 2100 Initial Configuration |
Here is an example:
rs(config)# system | set name "rs" | ||
rs(config)# | system | set | location "Houston, TX" |
rs(config)# | system | set | contact "John Smith" |
|
|
|
|
5.Use the interface add ip command to set the IP address and netmask for the en0 Ethernet interface. The en0 Ethernet interface is used by the RS 2100’s management port.
Here is an example:
rs(config)# interface add ip en0
Note The en0 interface is automatically created by the system and is reserved for the RS 2100’s management port.
6.To activate the system commands entered in the previous steps, use the following command:
save active
The CLI displays the following message:
Do you want to make the changes Active? [y]
7.Enter “y” to activate the changes.
8.To display the Active configuration, exit the Configuration mode, then enter the following command:
system show
Here is an example:
rs# system show
!
!Last modified from Console on Mon Jan 25 11:55:35 2001
1 : system set name "rs"
2 : system set location "Houston, TX"
3 : system set contact "John Smith"