Operating your radio - FM auto-tune
1.Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it is as straight as possible extending either above or below the clock radio.
2.Press the On / Standby button to switch on your clock radio.
3.Press and release the Mode button until the FM band is selected.
4.Press and hold down the Tuning Up button for 2 - 3 seconds to cause your radio to search from low frequency to high frequency and to stop automatically when it finds a station of sufficient strength.
5.After a few seconds the display will update. The display will show the frequency of the signal found. If the signal is strong enough and there is RDS data present then the radio may display the station name.
6.To find other stations press and hold the Tuning Up button as before.
7.Press and hold down the Tuning Down button for 2 - 3 seconds to cause your radio to search from high frequency to low frequency and to stop automatically when it finds a station of sufficient strength.
8.When the end of the waveband is reached your radio will recommence tuning from the opposite end of the waveband.
9.Adjust the Volume to the required setting.
10.To switch off your clock radio, press the On / Standby button.
If you need any further advice, please call our Technical Helpline on :-
2,10
3
4,6
7
99
020 8758 0338 | 12 |
