Manual tuning - FM
1.Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it is as straight as possible extending either above or below the clock radio.
2.Press the On / Standby button to switch on your clock radio.
3.Press and release the Mode button until the FM band is selected.
4.Press the Tuning Up or Down buttons to tune to a station. The frequency will change in steps of 50kHz.
If the radio is tuned to a station of sufficient signal strength with RDS information present, then the display may change to show the station name.
5.When the waveband end is reached the radio will recommence tuning from the opposite waveband end.
6.Set the Volume to the desired setting.
7.To switch off your clock radio press the On / Standby button.
2,7
3
4
4
66
13
