6To turn the WirelessHD kit off, perform one of the following steps:

•Power off your TV or projector and source devices - when the WirelessHD transmitter and receiver have not detected a signal, they will automatically go into sleep mode.

Note: When the WirelessHD transmitter and receiver go into sleep mode, the power and link status LEDs on both units will blink slowly.

Also note: Some HDMI source devices like TiVo set-top-boxes have no easy way to shut them off. The automatic HDMI port selection feature in the WirelessHD transmitter will therefore always select such an always-on source and will always keep the WirelessHD transmitter connected to the receiver. In this case please use steps below.

•Manually place the WirelessHD transmitter into sleep mode by pressing the SLEEP button on the included remote control (be sure to point the remote toward the WirelessHD transmitter).

•Turn the power switch on the WirelessHD transmitter and receiver to the OFF position.

7To return the WirelessHD transmitter and receiver from sleep mode to on, perform the following steps:

a)Power on the TV or projector, and switch it to the HDMI input with which the WirelessHD receiver is connected.

b)Power on the source device you wish to view that is connected to the WirelessHD transmitter.

Note: Depending on the brands/models of devices you have connected, the WirelessHD transmitter and receiver may automatically return from sleep mode and re-establish their link. If this does not happen with your devices, use the SLEEP button on the included remote control to manually return the WirelessHD transmitter and receiver from sleep mode.

HDMI-CEC (Consumer Electronics Control) support

For best operation, connect sources which are HDMI-CEC capable (DVD, Blu-ray player, and so on) to your WirelessHD transmitter. If your TV is also HDMI-CEC (v1.3a or newer) capable, your TV's OSD (on-screen display) should let you select any of the HDMI-CEC source devices connected to the WirelessHD transmitter adapters on the WVAN.

Turning off an HDMI-CEC enabled TV sends a broadcast message to all wired HDMI and WirelessHD source devices, giving them the opportunity to power off automatically (if they support HDMI-CEC and this option is enabled in the device's settings).

RF-WHD200 15