RocketFish RF-WHD200 Setting up the HDWireless Kit

Setting up the HDWireless Kit

Setup tips:

-Test the placement of the transmitter and receiver for a good signal prior to permanently mounting or installing everything.

-For best performance and range, mount the receiver vertically on the wall next to the TV (NOT behind the TV) or upside-down on the ceiling next to the projector, ensuring that the Rocketfish and WiHD logos can be seen from the position in the room where the transmitter will be located.

-Use only good quality high-speed HDMI cables for all connections, such as Rocketfish brand cables. Poorly constructed HDMI cables can negatively impact performance and may not support all of the features included with your connected source devices.

-Do not place the transmitter or receiver inside a cabinet or other location where they will not have a clear view of the room.

Refer to the following setup diagrams to arrange your transmitter and receiver. For best performance the transmitter and receiver should face each other, with the receiver mounted vertically to the wall next to the TV (not behind the TV) or upside-down on the ceiling next to the project, ensuring that the Rocketfish and WiHD logos can be seen from the position in the room where the transmitter will be located.

		Top view
		Transmitter		Side view
				16.4 ft. (5 m)
				47°
			Transmitter	32.8 ft. (10 m)	Receiver
	32.8 ft. (10 m)
				47°
82°	82°			16.4 ft. (5 m)

Floor

16.4 ft. (5 m) Receiver 16.4 ft. (5 m)

Note: The transmitter and receiver must be located within the same room. The wireless signal will not pass through walls, floors, or ceilings.

RF-WHD200 9