Problem | Solution |
|
|
|
|
|
|
| |
Sound interference | • Move the docking station slowly to find the best reception position for your | |||
| headphones. |
|
|
|
| • Shorten the distance between your headphones and the docking station. | |||
| The maximum distance is 98 feet (WHP02) or 65 feet (WHP01). | |||
| • Check if there are any obvious radio frequency interference sources near | |||
| your system. |
|
|
|
|
|
|
| |
No communication | • Make sure that the AC adapter is connected to the docking station. | |||
between the | • Check if the two supplied batteries are installed into the headphone battery | |||
headphones and | compartments. |
|
|
|
docking station | • Check if one or both batteries are exhausted. | |||
| WHP02: The headphones and docking station power indicators light up after the | |||
| headphone switch is set to ON and AUX IN/MIC IN is set on the docking system. | |||
| WHP01: The headphones and docking station power indicators light up after the | |||
| headphone switch is set to ON and the |
|
| /button on the docking system is |
|
|
| ||
|
|
| ||
| pressed. |
|
|
|
•If they are lit green solidly, then a communication link has been successfully established between the system.
•If they are blinking green on one, or both units, then press and hold the CONNECT button on the headphones and docking station for three seconds consecutively. (The headphones’ CONNECT button is on the left earpiece and the docking station’s CONNECT button is on its back.) This puts the system into the “connection mode” for about 30 seconds. The system proceeds with the connection process between the headphones and docking station. While in “connection mode”, the LED indicators of headphones and docking station blink between red and green alternatively. When an active link is established between the headphones and docking station, the LED indicators are solid on and will not blink.
Note: Try pressing the CONNECT button again if the LED indicators keep blinking after 30 seconds.
Specifications
Speaker | 40 mm Ferrite |
Impedance | 32 ohm |
|
|
Headphone type | Circumaural |
|
|
Headband | Auto Adjusting Headband |
|
|
Wireless type | 2.4 Ghz ISM band |
|
|
Distance | 98 feet (30 m) |
65feet (20 m)
Speaker input power 10 mW / 30 mW
24