Troubleshooting
Please read this User Guide carefully before using your universal wireless rear speaker kit. Check this list for a possible troubleshooting solution before calling for service.
Problem | Solution |
|
|
No sound | • Make sure that the AC adapter is connected to the sender and the power |
| cord is connected to the AC supply for the receiver. |
| • Make sure that all the cables are connected correctly. Check to see if the |
| LEDs illuminate on the front of both the sender and receiver units. If the |
| LEDs are lit solidly, the communication is working correctly and all speaker |
| wires and the amplifier operation should be checked. If the LEDs are |
| flashing, refer to the “No communication between the sender and receiver” |
| section below. |
Sound interference | • Move the sender and receiver slowly to find the best reception position for |
| your system. |
| • Shorten the distance between your sender and receiver. The maximum |
| distance is 100 feet. |
| • Check to determine if there are any obvious radio frequency interference |
| sources near your system. |
No communication between the sender and | • Make sure that the power cords are connected correctly. |
receiver | • After the power buttons have been pressed to turn on both the sender and |
| receiver, the front panel LEDs should light. If they are solidly on, a |
| communication link has been successfully established between the units. If |
| they are flashing on one or both units, press and hold the CONNECT button |
| on either the sender or receiver for two seconds. (The sender's CONNECT |
| button is on the bottom and the receiver's CONNECT button is on the back |
| panel.) This will put the unit into the “connection mode” for about 30 |
| seconds. During this period the CONNECT button on the other unit must |
| also be pressed for two seconds so that it will also enter “connection mode.” |
| The system proceeds with the connection process between the sender and |
| receiver. While in “connection mode,” the LED indicators blink at a faster |
| rate. When an active link is established between the sender and receiver, |
| the LED indicators will be solid on and will not blink. |
| Note: Try pressing the CONNECT buttons again if the LED indicators keep |
| blinking after 30 seconds. |