Using your universal wireless rear speaker kit

Establishing communications between the sender and receiver
To turn on the System:

1Press the (power) button on the back panel of the sender. The LED indicator blinks to indicate that the sender is plugged in and in Standby mode.

Blinking LED

2Press the (power) button on the back panel of the receiver. The LED indicator blinks to indicate that the receiver is plugged in and in Standby mode.

Blinking LED

The sender and receiver were pre-paired at the factory. When an active link is established between them, the LED indicators turn solid.

Note: In case the indicators continue to blink after 30 seconds, it means there is no active link between the sender and receiver. Try to connect the system manually using the CONNECT button. For more information, see “Troubleshooting” on page 15.

Listening to the system
To listen to the system:

1Power on the system. Make sure that there is an active link between the sender and receiver.

2Turn on your amplifier, then play the audio or video source through your amplifier.

RF-WHTIB 13