Using your system

Turning on your system
To turn on the system:

1Move the Power switch to the ON position on the side panel of the sender. The green Link Status LED starts to blink slowly to indicate the sender is plugged in and in Standby mode.

2Press the Power switch on the front panel of the speakers. The green Status LED starts to flash to indicate the receiver is plugged in and in Standby mode.

Note: If the speaker is operated by batteries and battery capacity is too low to power the speakers, the Low Battery Warning LED turns red to indicate a low battery warning.

The sender and speakers were pre-paired in the factory. When an active link is established between them the green Link Status LEDs turn solid.

Note: If the LEDs continue to blink after 30 seconds, it means there is no active link between the sender and speakers. Try to connect the system manually using the PAIR button. For more information see “Troubleshooting” on page 17.

Listening to your system
To listen to the system:

1Turn on the system. Make sure that there is an active link between the sender and speakers. When an active link is established between them the green Link Status LEDs turn solid.

2Turn on your audio source, then play the audio.

To adjust the volume on the RF-WS01 or RF-WS01-W:

•Turn the volume knob on the speaker. The volume is adjusted independently regardless of channel setting (left, right, or mono).

To adjust the volume on the RF-WS02:

•Turn the volume knob on the speaker. Make sure the speaker is switched to the correct left, right, or mono setting for speaker output sound.

RF-WS01/WS01-W/WS02 15