Punch Splits speakers with minimum path length differences will ensure the best staging and imaging possible from your audio system.
IN S TA L L AT I O N
The mounting of the Punch Splits speakers and crossovers is just as important as choosing the location for the speakers. Improper installation will degrade the sound quality and reduce the reliability of the Punch Splits speakers. To maximize the performance of your speakers, the following criteria should be considered.
•After choosing possible locations for the speakers, it is important to make sure there is a flat area large enough for the speaker to mount.
Warning !Failure to do this can cause damage to the speaker if the frame of the speaker is bent during the installation.
•Check to see that the location is deep enough for the speaker and the location does not interfere with the normal operation of the vehicle.
•When mounting the speakers in the door of a vehicle, special care should be taken to make sure the speaker/s do not interfere with either the window operation or the door opening and closing. (Be careful of the tension bar in the door.)
•When mounting the speakers on the rear deck of the vehicle, double check the operation of the rear hatch or trunk lid. Make sure the tension bars and other moving parts are not obstructed by the speakers’ installation.
Refer to the Specifications section of the manual for the mounting depth and proper diameter hole to cut for the Punch Splits speakers.
Mounting the Midrange
1.Cut the proper size hole for the midrange/woofer.
2.Place the mounting ring over the mounting hole and mark the location of the screw mounting holes.
3.Remove the ring. Drill the holes for the screws using a 1/8" drill bit.
4.Route the wire through the hole.
I
N S T A L L A T I O N
– 6 –
