SPECIFICATIONS
MODEL- PRIME |
| ||
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts | |||
4 | Load Per Channel | 50 Watts x 4 | |
2 | Load Per Channel | 75 Watts x 4 | |
4 | Load Bridged | 150 Watts x 2 | |
Dimensions: | Height | 2.40" (6.10cm) | |
|
| Width | 7.67" (19.49cm) |
|
| Length | 17.09" (43.40cm) |
Amplifier Fuse Rating (Amp) | (2) 25A ATC | ||
Battery Fuse Rating (Amp) External (Not Supplied) | 50A | ||
| “A” Weighted Signal to Noise Ratio |
| |
| Referenced to 1 Watt into 4 ohms | ≥70 dB | |
| “A” Weighted Signal to Noise Ratio |
| |
| Referenced to rated output into 4 ohms | ≥90 dB | |
| Crossover Slope | 12dB/octave Butterworth | |
| Crossover Frequency | High Pass @ 80Hz, Low Pass variable from 50Hz to 250Hz | |
| Frequency Response | 20Hz to 20KHz ±1dB | |
| Signal Voltage Adjustment Range | Variable from 150mV to 8V (RCA Input) | |
| Protection |
| Short circuit protection shut downs the amplifier in |
|
|
| case of very low impedance or shorted speaker wires. |
| Punch Level |
| Selectable between 0dB, +6dB and +12dB @ 45Hz |
| Input Impedance | 20K ohms | |
| Operating Voltage | 9 to 16 Volts DC | |
| Balanced Inputs | No | |
| CMRR (Common Mode Rejection Ratio) | >40dB @ 1KHz | |
| Damping Factor | >200 | |
| THD+N (Total Harmonic Distortion + Noise) | < 1.0% @ 4 ohm | |
These specifications are Amplifier Power Standard
Specifications subject to change without notice
10
