Rockford Fosgate RFX9000 manual Volume KNOB/TONE Controls, Setup Options

OPERATION-BASIC

VOLUME KNOB/TONE CONTROLS

The Volume knob is a multifunction controller and handles the Volume, Tone Controls, and Setup Options, see below.

To Control Volume

1.Turn the VOLUME knob clockwise to raise volume.

2.Turn the VOLUME knob counter-clockwise to lower volume.

To Adjust Tone Controls

1.Press the VOLUME knob (SEL button) repeatedly to cycle through BASS > TREBLE > BALANCE > FADER > VOLUME.

2.Turn the VOLUME knob to increase, clockwise, or decrease,

counter-clockwise, the selected function. (VOL Buttons / on the remote work as well.)

Source Tone Memory

DISP

VOL

PUSH

MENU

Remote

DIR

MODE

DIR

Individual Bass & Treble settings are memorized for TUNER and CD PLAYER.

NOTE: If no adjustment is made after 5 seconds, the MENU knob will revert to VOLUME mode.

SETUP OPTIONS

The list below shows the default Setup Options. The bracketed items are the alternate options contained within each Setup Option.

Selecting Options

1.Press and hold the VOLUME knob (SEL button) for about 1 second until the first Option appears {AMERICAS}.

2.Press the VOLUME Knob repeatedly to cycle through all Setup Options. The first two options only affect the Tuner Mode.

3.To change an Option, press either DIR / Buttons (SEEK or ).

4.To store, wait 5 seconds and the Display will return to the last Mode shown.

•AMERICAS [EUR/AUST] — Allows tuning of frequencies available in different parts of the world.

•P. PLAY [EJ MUTE] — Plays the Tuner after you eject a CD while Eject Mute mutes the Tuner after you eject a CD.

•V/BAR ON [V/BAR OFF] — Displays the Volume Bar at the bottom of the Front Panel while Volume Bar Off turns it off.

•INI VOL 15 — Sets the maximum Initial Volume when the unit turns on. Initial Volume sets point of maximum volume when the unit is turned on. If the volume set- ting was lower than the initial volume setting when the unit is turned off, then the lower volume will be used at turn on. If the volume setting was higher than the initial volume setting, then the initial volume setting is used at turn on. This feature prevents accidental high volume turn on as well as allows high volume settings to be retained in case another preamplifier is the system’s main volume control.

13