TROUBLESHOOTING
Speaker Hum – If hum can be heard from more than a few inches from the loudspeaker, there is probably a ground loop. If there is still hum, flip the grounded/ungrounded switch on the rear panel to ungrounded. If this fails to cure the hum, call customer service at Rogue Audio for further advice.
Tube will not bias – If the meter provides a reading but the tube will not bias, the tube is probably bad. If no meter reading can be attained, check the fuse (1/4 Amp fast blow). If the fuse is bad, replace the fuse and then set the bias. If the bias will not maintain itself and the fuse blows again, the tube should be replaced.
Bias Meter reading is too high – Check that you do not have two of the bias switches turned on.
Output sounds distorted - Check the bias on the output tubes to ensure that the tubes are operating properly.
OWNER AND WARRANTY REGISTRATION FORM
Included with this manual is an Owner and Warranty Registration Form. Please take a minute to fill out this card and return it to Rogue Audio. This card must be returned within 30 days of purchase to validate the warranty.
FUSE VALUES
Main fuse located on rear panel (1) – 5 Amp slow blow
Tube Fuses (4) – 2/10 Amp slow blow
Power Supply Fuse on PCB (1) – ¾ Amp slow blow
| SPECIFICATIONS |
output power | 150 WPC |
frequency response | 5Hz – 50 kHz ± 1dB |
THD | < 0.1% typ, < 1% at rated power |
input sensitivity | 1.0 V RMS |
dimensions | 14 ½” W x 19” D x 7” H |
weight | 55 pounds (25 Kg) |
shipping weight | 60 lbs (27 Kg) |
power requirements | 115/230V - 50/60Hz |
8