Rogue Audio Tempest Vacuum Tube Integrated Amplifier owner manual Ohm Binding Wire Feedback Post

7)Matching Speaker Impedance - The Rogue Tempest provides options for either 4 ohm or 8 ohm speakers. The impedance selected will depend on the speakers used. Consult either the owner’s manual for your speaker or your local dealer to determine the correct choice. To switch impedance setting, refer to Figure 3. Note - the amplifier is factory set for 8-ohm speakers.

⇒Using a 5/16” wrench, remove the outermost nut from the red binding post.

⇒Remove the wire and lug marked 8 ohm from the binding post. Leave the wire and lug marked feedback in place.

Warning -Never remove the lugs marked feedback or ground from the binding posts. Doing so could cause permanent damage to the unit

⇒Remove the polyurethane tubing from the unused 4-ohm wire and lug.

⇒Place 4-ohm wire and lug onto red binding post.

4 Ohm	Binding
Wire		Feedback
	Post
		Wire
		8 Ohm
		Wire

Figure 3

Rogue Tempest Owners Manual 5