Roland AT 5 Before You Start Playing, Setting Up the Music Stand, Connecting the AC Adaptor

Before You Start Playing

Setting Up the Music Stand

1.Attach the music stand by inserting it into the two holes.

Connecting the AC Adaptor

1.First, make sure that the [Power On] switch at the panel’s left side is OFF (not pushed in).

2.Connect the supplied AC adaptor and power cord.

3.Connect the AC adaptor to the DC In jack on the rear panel.

4.Loop the AC adaptor cord around the cord hook to fasten it in place.

*To prevent the inadvertent disruption of power to your unit (should the plug be pulled out accidentally), to avoid applying undue stress to the DC In connector, anchor the power cord using the cord hook, as shown in the diagram. Even if the cord is fastened, strong tension applied to the cord may cause it to be damaged or broken. Be careful not to pull the cord accidentally, or to apply strong pressure to it.

5.Plug the power cord into a power outlet.

*Only use the power cord and AC adaptor supplied with this instrument.

*Whenever you do not intend to use the instrument for extended periods of time, pull out the power cord from the AC outlet.