28
Additional Convenient Functionality <Advanced Operation>
■
Changing the BASS split point
You can change the note range assigned to the PEDAL
division (see the “BASS” indication above the keyboard) by
proceeding as follows:
1.
Press and hold the upper part of the [SUBBASS 16] tilt
tab so that it flashes.
2.
While holding down the [SUBBASS 16] tilt tab, press
the key that should become the new split point.
3.
Release the [SUBBASS 16] tilt tab.
The PEDAL division can now be played in the range up
to the note immediately to the left of the key you
pressed.
The “BASS” split point cannot be moved beyond the B3.
Pressing a key to the right of the B3 has no effect.
■
Changing the MANUAL I/MANUAL II split
point
You can move the split point that separates the MANUAL I
division from the MANUAL II division by proceeding as
follows:
1.
Switch off the [Coupler II/I] tilt tab if it lights.
2.
Press and hold the upper part of [STILL GEDACKT 8]
tilt tab so that it flashes.
3.
While holding down the [STILL GEDACKT 8] tilt tab,
press the key that should become the new split point.
4.
Release the [STILL GEDACKT 8] tilt tab.
The separation between the MANUAL I and
MANUAL II division is now located at the key you just
pressed (this is the lowest note of the MANUAL II sec-
tion).
To preserve this setting even after switching the C-200
off, you need to save it to the Global area (see p. 33).
The split point between the MANUAL I and
MANUAL II divisions cannot be moved below the C4.
Pressing a key to the left of the C4 has no effect.
Changing the split pointsC4
C4
C-200_02_e.fm Page 28 Tuesday, April 5, 2011 3:00 PM