•Do not force the unit’s power-supply cord to share an outlet with an unreasonable number of other devices. Be especially careful when using extension cords—the total power used by all devices you have connected to the extension cord’s outlet must never exceed the power rating (watts/amperes) for the extension cord. Excessive loads can cause the insulation on the cord to heat

up and eventually melt through.

..........................................................................................................

•Before using the unit in a foreign country, consult with your retailer, the nearest Roland/EDIROL

Service Center, or an authorized Roland/EDIROL distributor, as listed on the “Information” page.

..........................................................................................................

•The unit should be located so that its location or

position does not interfere with its proper ventilation .

..........................................................................................................

•Always grasp only the plug on the power-supply

cord when plugging into, or unplugging from, an outlet or this unit.

..........................................................................................................

•Try to prevent cords and cables from becoming entangled. Also, all cords and cables should be

placed so they are out of the reach of children.

..........................................................................................................

•Never climb on top of, nor place heavy objects on the unit.

..........................................................................................................

•Never handle the power cord or its plugs with wet

hands when plugging into, or unplugging from, an outlet or this unit.

..........................................................................................................

•Before moving the unit, disconnect the power

plug from the outlet, and pull out all cords from external devices.

..........................................................................................................

•Before cleaning the unit, turn off the power and

unplug the power cord from the outlet.

..........................................................................................................

•Whenever you suspect the possibility of lightning

in your area, pull the plug on the power cord out of the outlet.

..........................................................................................................

•Should you remove the optical connector cap, make sure to put them in a safe place out of children's reach, so there is no chance of them

being swallowed accidentally.

..........................................................................................................

IMPORTANT NOTES

In addition to the items listed under “IMPORTANT SAFETY INSTRUCTIONS” and “USING THE UNIT SAFELY” on pages 3 and 4, please read and observe the following:

Power Supply

•Do not use this unit on the same power circuit with any device that will generate line noise (such as an electric motor or variable lighting system).

•Before connecting this unit to other devices, turn off the power to all units. This will help prevent malfunctions and/or damage to speakers or other devices.

Placement

•This device may interfere with radio and television reception. Do not use this device in the vicinity of such receivers.

•Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. Also, do not allow lighting devices that normally are used while their light source is very close to the unit (such as a piano light), or powerful spotlights to shine upon the same area of the unit for extended periods of time. Excessive heat can deform or discolor the unit.

•To avoid possible breakdown, do not use the unit in a wet area, such as an area exposed to rain or other moisture.

•Do not allow rubber, vinyl, or similar materials to remain on the unit for long periods of time. Such objects can discolor or otherwise harmfully affect the finish.

4