60
Chapter 6 Using the Built-in Effects
13: SPACE-D
Space-D is a multiple chorus that applies two-stage
modulation in stereo. It does not produce a sense of
modulation, but creates a transparent chorus effect.
fig.6-17
PRE DELAY (Pre delay time) 0.0–100 ms
Specify the delay time from the original sound until the
chorus sound is heard.
RATE 0.05–10.0 Hz #
Specify the modulation frequency of the chorus sound.
DEPTH 0–127
Specify the modulation depth of the chorus sound.
PHASE 0–180
Specify the spaciousness of the chorus sound.
LOW GAIN -15–+15 dB
Specify the gain (amount of boost or cut) for the low
frequency range.
Positive (+) settings will emphasize (boost) the low
frequency range.
HIGH GAIN -15–+15 dB
Specify the gain (amount of boost or cut) for the high
frequency range.
Positive (+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect balance) D100:0E–D0:100E
Specify the volume balance between the original sound and
the chorus sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the chorus sound
will be output.
LEVEL (Output level) 0–127
Specify the output volume.
14: STEREO-CHO (Stereo Chorus)
This is a stereo chorus. A filter allows you to adjust the tone
of the chorus sound.
fig.6-18

FILTER TYPE Off/LPF/HPF

Select the type of filter.
Off:
A filter will not be used.
LPF:
The frequency region above the Cutoff Freq setting will
be cut.
HPF:
The frequency region below the Cutoff Freq setting will
be cut.

CUTOFF FREQ (Cutoff frequency)

200/250/315/400/500/630/800/1000/1250/1600/2000/2500/3150/
4000/5000/6300/8000 (200–8000 Hz)
Specify the frequency at which the filter will begin cutting.
PRE DELAY (Pre delay time) 0.0–100 ms
Specify the time delay from the original sound until the
chorus sound is heard.
RATE 0.05–10.0 Hz #
Specify the modulation frequency of the chorus sound.
DEPTH 0–127
Specify the modulation depth of the chorus sound.
PHASE 0–180
Specify the spaciousness of the chorus sound.
LOW GAIN -15–+15 dB
Specify the gain (amount of boost or cut) for the low
frequency range.
Positive (+) settings will emphasize (boost) the low
frequency range.
HIGH GAIN -15–+15 dB
Specify the gain (amount of boost or cut) for the high
frequency range.
Positive (+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect balance) D100:0E–D0:100E
Specify the volume balance between the original sound and
the chorus sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the chorus sound
will be output.
LEVEL (Output level) 0–127
Specify the output volume.
L in
R in
Space D
Space D
L out
R out
2-Band
EQ
2-Band
EQ
Balance E
Balance E
Balance D
Balance D
L in
R in
Chorus
Chorus
L out
R out
2-Band
EQ
2-Band
EQ
Balance E
Balance E
Balance D
Balance D