Roland KC-60 owner manual Making the Connections, Control Panel Rear Panel

Making the Connections

Refer to the figure shown below to connect the KC-60 and the other equipment.

fig.03

Control Panel Rear Panel

Stereo

Headphone

Microphone

INPUT	INPUT	OUTPUT
		CD Player
Subwoofer	Mixer	Drum Machine

(With built-in amp)

OUTPUT

Keyboard

Here is an example of a setup that makes full use of the KC- 60’s mixer and monitor functions.

A microphone is input to CH 1, which accepts mic level input. Connect a keyboard, recorder, or other sound- generating device to the CH 2 and CH 3 inputs.

*To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. Set all of the KC- 60’s channel volume knobs as well as the VOLUME knob to zero.

*The pin assignment for the XLR type connectors is as shown below. Before making any connections, make sure that this pin assignment is compatible with that of all your other devices.

*Howling could be produced depending on the location of microphone relative to speakers. This can be remedied by:

1.Changing the orientation of the microphone.

2.Relocating microphone at a greater distance from the speaker.

3.Lowering volume levels.

*When connection cables with resistors are used, the volume level of equipment connected to the inputs (CH 1 through CH 3 and AUX IN) may be low.

If this happens, use connection cables that do not contain resistors, such as those from the Roland PCS series.

fig.04

8