16
1. Preparing the Machine
1-3 Installing and Setting Up the Software
Here you connect the machine to your computer and install and set up the included software on the computer, enabling
you to perform scanning with the machine.

Installing the Driver

Connect the machine to the computer and install the driver.
Be sure to follow this procedure to install the driver. Failure to do so may make installation impossible.
☞ Go to "1-3 Installing and Setting Up the Software," see "What to Do If Installation Is Impossible."
Procedure
Windows XP
1
Start Windows and log on as "Administrator."
2
Insert the Roland Software Package CD-ROM
into the CD-ROM drive.
The setup menu appears automatically.
3
Switch on the machine.
Wait a short while until the light stops flashing.
The flashing continues for about one minute.
From this point on, keep the machine's door closed
until installation ends. Failure to do so switches off
the power, which may prevent installation from com-
pleting correctly.
4
Connect a USB cable (sold separately).
The [Found New Hardware Wizard] dialog appears. USB connector
USB port
USB cable
These lights flash clock-
wise two at a time.
Press the power button.
The rear of
the machine
Computer