For Best Imprinting Results - Part 1
Loading a material
METAZA is a precision instrument. To obtain the best imprinting results, loading the workpiece with care is very IMPORTANT. See User’s manual “Part 2 Performing Marking” for instructions on how to mark materials.
1.Place the adhesive sheet and the material in the correct position
1)Align the upper right corner of the adhesive sheet with the corner of the work table and set in place.
2)Place the adhesive sheet on the work table so that the widest margin is in front (which is the screw side).
3)Place the workpiece at the center of the work table where the grid lines cross in the middle.
*If the adhesive sheet is in the wrong position, you will not get a good result.
*If you are a first time user of the METAZA, try using the trial material included in the package first. Should the METAZA impact where it is not desired, refer to the User’s manual Part 5 “The marked position isn’t where desired” for details.
Yes
The wide margin should be in front
No
The adhesive sheet is placed front side back on the work table.
The adhesive sheet is not aligned with the upper right corner of the work table.
The workpiece is not in the center of the work table.
3