• Attach the pad to a stand with care to avoid danger
of pinching the fingers.
............................................................................................................
• Do not apply excessive force to the sensor located below the center of the head. Doing so can interfere with accurate detection, and may damage it.
............................................................................................................
• Due to the nature of the materials used in the
sensor, changes in room temperature may affect the sensitivity of the sensor.
............................................................................................................
• Brushes can be used to play the
the head, but can also be hazardous, since the tip of the brush may catch in the mesh of the net.
............................................................................................................
• This unit is shipped from the factory with the head tension loosened. Be sure to tighten the tension before use. Striking the head when the head tension
is loose may damage the sensor and head.
............................................................................................................
• The hoop’s rubber portion is one component that eventually wears out (the more so if numerous rim shots are performed), and will require replacement. Rim shots may not be performed correctly when the rubber portion is worn out. If this occurs, replace
the hoop rubber. Consult Roland Service for more on replacing the hoop rubber.
............................................................................................................
IMPORTANT NOTES
In addition to the items listed under “USING THE UNIT SAFELY” on pages
Placement
•Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. Excessive heat can deform or discolor the unit.
•When moved from one location to another where the temperature and/or humidity is very different, water droplets (condensation) may form inside the unit. Damage or malfunction may result if you attempt to use the unit in this condition. Therefore, before using the unit, you must allow it to stand for several hours, until the condensation has completely evaporated.
•Do not allow rubber, vinyl, or similar materials to remain on the unit for long periods of time. Such objects can discolor or otherwise harmfully affect the finish.
Maintenance
•For everyday cleaning wipe the unit with a soft, dry cloth or one that has been slightly dampened with water. To remove stubborn dirt, use a cloth impregnated with a mild,
•Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or defor- mation.
Additional Precautions
•Use a reasonable amount of care when using the unit’s buttons, sliders, or other controls; and when using its jacks and connectors. Rough handling can lead to malfunctions.
•When connecting / disconnecting all cables, grasp the connector
•To avoid disturbing your neighbors, try to keep the unit’s volume at reasonable levels. You may prefer to use headphones, so you do not need to be concerned about those around you (especially when it is late at night).
•This instrument is designed to minimize the extraneous sounds produced when it’s played. However, since sound vibrations can be transmitted through floors and walls to a greater degree than expected, take care not to allow these sounds to become a nuisance to neighbors, especially when performing at night and when using headphones.
•When you need to transport the unit, package it in the box (including padding) that it came in, if possible. Otherwise, you will need to use equivalent packaging materials.
For EU Countries
This product complies with the requirements of European Directive 89/336/EEC.
7
