7
Getting Ready
fig.BattCase.e_50
1.
Press down and slide off the lid of the battery
compartment (located on the bottom of the unit).
2.
Connect the snap cord to the battery, and place it inside
the battery compartment.
* Verify the battery’s polarity (+ versus -).
3.
Securely close the battery cover.
* Do not let the snap cord get caught in the battery compartment lid.
When to Change the Battery
The Battery LOW indicator ( ) at the lower right of the
display begins to flash when the battery power drops.
Insufficient battery power lowers the volume level of the mini speaker and causes unstable
operation. Replace the battery as soon as possible.
* We recommend replacement with alkaline batteries.
A BOSS PSA series AC adaptor (sold separately) can be used to power the RMP-5.
fig.Bolt
BEFORE playing the RMP-5, you must tune the head to your
preferred playing tension. The head is NOT tuned before shipping.
Always tighten the tuning bolts in the order shown in the figure.
* Failure to adjust the tension may result in damage to the head.
* Head tension may change with extended use. Make adjustments as needed.
Loading the Battery
Connecting the AC Adaptor
Adjusting the Head Tension
Battery
Snap
9V
Battery
Use only the BOSS PSA-series
AC adaptor. Other adaptors
may cause malfunction or
damage to the RMP-5 and
must never be used.
Turn off the power before
connecting the AC adaptor.
1
7
8
63
45
2
RMP-5_e.book 7ページ ２００５年８月１１日 木曜日 午後２時４７分