Roland TD-6K manual Check the Contents of the Box, Setting the Polarity Switch, MDS-6 Drum Stand

Check the Contents of the Box

❑TD-6 (Percussion Sound Module) x 1

❑KD-7 (Kick Trigger Unit) x 1

❑FD-6 (Hi-Hat Control Pedal) x 1

❑PD-6 (Pad) x 5

❑CY-6 (Cymbal Pad) x 2

❑Accessory Set x 1

❑ Tuning Key x 1

❑ Beater (for KD-7) x 1

❑ Anchor Bolt (for FD-6) x 2

❑ Spring for Anchor Bolt (for FD-6) x 2

❑ Wing Nut (for CY-6) x 2

❑ Felt Washer (for CY-6) x 2

❑ Stopper (for CY-6) x 2

❑Monaural Connection Cable (1 meter) x 3 (for Hi-Hat, Snare, Tom1: PD-6 x 3)

❑Monaural Connection Cable (2 meters) x 4 (for Kick: KD-7/Tom2, 3: PD-6 x 2/ Hi-Hat Control Pedal: FD-6)

❑Stereo Connection Cable (2 meters) x 2 (for Crash, Ride: CY-6 x 2)

■TD-6K Owner's Manual x 1

•This package does not include a kick pedal. Use with a commercially available kick pedal.

•The TD-6 Owner's Manual is included in the TD-6 package.

In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice.

MDS-6(Drum Stand)

Assemble the Drum Stand.

About the Stand (MDS-6), refer to the owner’s manual for the stand.

TD-6(Percussion Sound Module)

Attach the stand holder (included with the drum stand MDS-6) to the TD-6.

Narrow

Wide

•To attach the stand holder, remove the four 8 mm screws (M5 x 8) from the bottom of the TD-6 and use them. Use of other screws may result in damage to the unit.

•When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to orient the unit so no buttons or controls get damaged.

•When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip over.

KD-7(Kick Trigger Unit)

Pad Face

Anchor Bolt

Foot Plate

Output Jack

Mix In Jack

Low High

Output Level Control

Polarity Switch

Setting the Polarity Switch

Move the polarity switch to the “(-Roland)” position.

4