21
Chapter 1 Outputting Sounds
Chapter 1
Use this procedure to set the type of device connected to the MAIN
OUT jacks.
fig.01-071
1.
Press [GLOBAL].
The Global screen is displayed.
fig.01-072d
2.
Press PAGE [ ] to go to Page 1.
3.
Press [F4] (SELECT) or turn the F4 knob to set
the type of device to be connected to the MAIN
OUT jacks.
4.
Press [EXIT] to return to the Play screen.
The VB-99’s sound characteristics vary greatly depending on how
the divided pickup is installed. To ensure consistent conditions for
optimal sound production, be sure to make the settings affecting the
divided pickup (the GK settings). With these settings appropriately
made, the VB-99 can then operate under optimal conditions.
* For information on parameters not described in this chapter, refer to
“GK SETTING”
(p. 145).
When using more than one bass with the VB-99, you can
save the settings for each bass separately.
fig.01-100
1.
Press [SYSTEM].
The System screen is displayed
2.
Press PAGE [ ] to go to Page 1.
3.
Press [F3] (GK).
The GK Settings screen is displayed.
fig.01-060d
4.
Press PAGE [ ] [ ] to go to Page 2.

Setting the Device (Amp)

Connected to MAIN OUT (Output

Select)

Value Explanation
AMP WITH TWEETER
Use this setting when connecting to a tweet-
er-equipped bass amp.
AMP NO TWEETER
Use this setting when connecting to a bass
amp that has no tweeter. The high-frequen-
cy range is adjusted.
LINE/PHONES
Use this setting when using headphones or
connecting directly to a PA system or multi-
track recorder.
3
3
4
1
2
Inputting the Divided Pickup Settings (GK Settings)
The GK settings are extremely important to getting
good tones from the VB-99. Be sure to input the
settings correctly.
3
4
1
2
5 6
7 9
12
10 11
8
VB-99_e.book 21 ページ ２００８年８月１８日　月曜日　午後１時１０分