53
EFFECTS Chapter 5. Parameter Guide
Chapter 5
This effect adds delayed sound to the direct sound, giving
more body to the sound or creating special effects.
ON/OFF
Switches the DELAY on/off.
* Turning [VALUE] will select PRESET.
DLY TIME (delay time)
[0–1800 msec, BPM –BPM ]
This determines the delay time.
* When set to BPM, the value of each parameter will be set
according to the value of the BPM (p. 55) specified for each
patch. This makes it easier to achieve effect sound settings that
match the tempo of the song (synchronizing the time to twice
or four times the time length of the BPM when the set time is
increased).
* To adjust the setting in 1 msec units, press [F4] (FINE).
TAP TIME [OFF, 0–100%]
Adjusts the delay time of the right channel delay. This setting
adjusts the right channel delay time relative to the left
channel delay time (considered as 100%).
FEEDBACK [0–100]
“Feedback” is returning a delay signal to the input. This
parameter determines the amount of feedback. A higher
value will increase the number of the delay repeats.
HIGH CUT (high-cut filter)
[700 Hz–11.0 kHz, FLAT]
The high-cut filter cuts the frequency contents that are higher
than the set frequency. This parameter adjusts the frequency
where the high-cut filter starts working. When it is set to
“Flat,” the high-cut filter does not work at all.
DLY LEV (delay level) [0–120]
Adjusts the volume of the delay sound.
In this effect, a slightly detuned sound is added to the
original sound to add depth and breadth.
ON/OFF
Switches the CHORUS on/off.
* Turning [VALUE] will select PRESET.
MODE
Selection for the chorus mode.
MONO:
This chorus effect outputs the same sound from both L
and R.
STEREO:
This is a stereo chorus effect that adds different chorus
sounds to L and R.
RATE [0–100, BPM –BPM ]
Adjusts the rate of the chorus effect.
* When set to BPM, the value of each parameter will be set
according to the value of the BPM (p. 55) specified for each
patch. This makes it easier to achieve effect sound settings that
match the tempo of the song.
DEPTH [0–100]
Adjusts the depth of the chorus effect. To use it for doubling,
set the value to “0.”
PRE DLY (pre delay)
[0.0–40.0 msec] (0.5 msec steps)
Adjusts the time needed for the effect sound to be output
after the direct sound has been output. By setting a longer
pre delay time, you can obtain an effect that sounds like
more than one sound is being played at the same time
(doubling effect).
HIGH CUT (high-cut filter)
[700 Hz–11.0 kHz, FLAT]
The low-cut filter cuts the frequencies below the specified
frequency. This setting adjusts the frequency at which the
low-cut filter will begin to take effect. When “FLAT” is
selected, the low-cut filter will have no effect.
CE LEVEL (chorus level) [0–100]
Adjusts the volume of the chorus sound.
DELAY CHORUS