MIC 1
+6 dB +50 LINE 1
MIC 2
+6 dB +50 LINE 2
MIC 3 | PHANTOM | AUX 1 | |
| SEND | ||
| PWR |
| |
| 4/LEFT/MONO | ||
+6 dB +50 |
|
| |
LINE 3 | 5/RIGHT | ||
|
|
AUX 2
SEND
6/LEFT/MONO
7/RIGHT
LEFT OUT
8/LEFT/MONO
9/RIGHT
RIGHT OUT
AUX 1
RET LEFT/MONO
AUX 1
RET RIGHT
to Effects Input | from | from |
Left Output | Right Output |
STEREO EFFECTS DEVICE
SIGNAL PROCESSOR CONNECTION
Use Aux 1 Output to connect to the Input of your signal processor which may be an echo unit, a reverb, or multi effects unit. Aux 1 is used because the signal is taken after the channel fader which is a typical setup for a signal processor. The right and left outputs of the processor are then connected to the Aux 1 Right and Left Return jacks. The level of signal going into the signal pro- cessor is controlled by the Aux 1 control on each individual MX902 channel, and the signal processor’s input level control. The level of signal going back into the MX902 is controlled by Aux 1 Return Level control on the MX902 front panel, and by the signal processor’s output level control.
4