Rotel RCD-06 SE owner manual External Remote Input w, 12V Trigger Connection q, Troubleshooting

English
	9

External Remote Input w

This 3.5 mm mini-jack (labeled EXT REM IN) receives command codes from an industry-standard infrared receiver (Xantech, etc.) located in the main listening room. This feature is useful when the unit is installed in a cabine and the front-panel sensor is blocked. Consul your authorized Rotel dealer for information on external receivers and the proper wiring o a jack to fiit the mini-jack receptacle.

12V Trigger Connection q

The RCD-06 SE can be activated by a 12 volt trigger signal from a Rotel preamplifiier. The trigger input accepts any control signal (AC or DC) ranging from 3 volts to 30 volts. When a cable is connected to the input and a trigger signal is present, the CD Player is activated.

When the trigger signal is interrupted, the unit goes into standby mode. The front panel indicator light remains lit , but the display goes dark and the unit will not operate.

Note: When using the 12V Trigger feature, leave the POWER button in the ON position.

Troubleshooting

Most diffiiculties in audio systems are the result of incorrect connections, or improper control settings. If you encounter problems, isolate the area of the diffiiculty, check the control settings, determine the cause of the fault and make the necessary changes. If you are unable to get sound from the RCD-06 SE, refer to the suggestions for the following conditions:

Power Indicator Is Not Lit

The Power Indicator and the basic items in the Display window should be lit whenever the RCD-06 SE is plugged into the wall power outlet and the Power button is pushed in. If it does not light, test the power outlet with another electrical device,such as a lamp. Be sure the power outlet being used is not controlled by a switch that has been turned off.

Fuse Replacement

If another electrical device works when plugged into the power outlet, but the Power Indicator and the Display still will not light when the RCD-06 SE is plugged into the wall outlet, it indicates that the internal power fuse may have blown. If you believe this has happened, contact your authorized Rotel dealer to get the fuse replaced.

NO SOUND

Check the cables between the RCD-06 SE and the amplifiier inputs to be sure they are connected properly. Be sure the correct amplifiier input is selected. Be sure the tape monitor system of the amplifiier has not been activated. Check the wiring between the amplifer and the speakers.

Specifications

Total Harmonic Distortion + Noise	0.0045%@1kHz
Intermodulation Distortion	0.0045%@1kHz
Frequency Response (±0.5db)	20-20,000 Hz
Channel Balance	±0.5db
Phase Linearity	±0.5degree
Channel Separation	> 98 dB @ 1kHz
Signal to Noise Ratio	> 100dB
Dynamic Range	> 96 dB
Digital to Analog Converters	Wolfson
Speed Accuracy, Wow & Flutter	Quartz Crystal Precision
Output Impedance	100 Ohms
Digital Output	0.5 Volt, Peak to Peak
Load Impedance	75 Ohms
Power Requirements	AC 230V, 50 Hz
Power Consumption	20 Watts
Dimensions (W, H, D)	171/8" x 27/8" x 125/16"
	437 x 73 x 313 mm
Panel Height	60 mm / 23/8"
Weight (net)	5 kg, 11lbs

All specifications are accurate at the time of printing.

Rotel reserves the right to make improvements without notice.

Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.