| 8 |
Troubleshooting | Specifications |
|
Most difficulties in audio systems are the result | Power Configurations | 6 x 100 watts |
of poor or wrong connections, or improper | Watts/Channel | 100 watts |
control settings. If you encounter problems, | All channels driven, with 20KHz filter unbridged, 8ohm, 20 to 20kHz, <0.02%THD | |
isolate the area of the difficulty, check the | Total Harmonic Distortion | < 0.02% |
control settings, determine the cause of the | At rated power, |
|
fault and make the necessary changes. If you | Intermodulation Distortion | < 0.03% |
are unable to get sound from the | At rated power, 60 Hz : 7 kHz, 4:1 |
|
refer to the suggestions for the following | Power Output 4 ohms, 1.0% THD | 180 watts |
conditions: | Frequency Response ±3 dB | |
Front Panel Power Indicator Is | Damping Factor 8 ohms | 200 |
Signal to Noise Ratio IHF A network | 105 dB | |
Not Lit | Amp Gain | 27.2dB |
No main power to the | Input Sensitivity / Impedance | 1.25V/8.2 kohms |
power connections at the amplifier and the | Auto Turn On Threshold Level (if activated) | 10 mV input signal |
AC outlet. Check the front panel power switch. | Power Requirements |
|
Make sure that it is set to the ON position. If | USA: | 120 Volts, 60 Hz |
using signal sensing auto | Europe: | 230 Volts, 50 Hz |
sure that a signal is present at the inputs. If | Power Consumption | 300 Watts |
using 12V trigger | Output Peak Current | 11A |
a trigger signal is present at rear panel screw | Idling Power Consumption | 70 watts |
terminals. | Standby Power Consumption | 6 watts |
No Sound | Dimensions (W x H x D) | 432 x 72 x 382 mm |
| 17 1/8 x 9 3/8 x 15 1/8 in | |
If the amp is getting AC power, but is producing | Front Panel Height (for rack mount) | 60mm |
no sound, check the PROTECTION INDICATOR | Weight (net) | 5.7 kg, 12.5 lb. |
on the front panel. If lit, see below. If not, check |
|
|
all of your connections and control settings on | All specifications are accurate at the time of printing. |
|
associated components. Make sure that your | Rotel reserves the right to make improvements without notice. |
|
input connections and speaker connections |
|
|
match your selected configuration. |
|
|
Protection Indicator Is Lit
The front panel PROTECTION INDICATOR is lit when the