Clean position (fig.5) : steam will now begin to build up. After a few seconds water will merge from the soleplate, rinsing dirt and scale particles out of the steam chamber. Move the steam control to position after approx. 1 minute. Plug in the iron and allow the iron to heat up again. Wait until the remaining water has evaporated. Unplug from the mains and allow the iron to fully cool down.

When cool, the soleplate can be wiped with a damp cloth.

TIP Use the Self Clean function approx. every 2 weeks. If the water is very hard, clean the iron weekly.

18 • Cleaning the iron

When the appliance has cooled down, wipe it down with a damp cloth or sponge, as required. Remove the dirt from the soleplate with a damp cloth or sponge.

IMPORTANT Do not use sharp or abrasive cleaning agents or objects to clean soleplate and other parts of the iron.

If the appliance has been standing unused for long periods, use the Self Clean function (see § 17).

PROBLEMS?

Problems

Cause

Solution

 

 

 

The iron is

No mains supply.

Check that the mains plug is properly

plugged in, but

 

inserted or try plugging the iron into

the soleplate of

 

a different socket.

the iron

 

 

remains cold.

Temperature control

Set the temperature control to a

 

set too low.

higher temperature.

 

 

 

 

The automatic

Move your iron.

 

electronic cut-out*

 

 

is active.

 

 

 

 

Thermostat

This is normal.

When the thermostat control light*

control light*

 

or the yellow led* goes on and off

or the yellow

 

the iron is heating up. As soon as the

led* goes on

 

thermostat control light* goes off or

and off.

 

the green led* lights up the set

 

 

temperature has been reached.

 

 

 

Yellow and red

The electronic has

Contact an official Rowenta

LED are

an internal failure.

Customer service.

blinking

 

 

alternately.

 

 

 

 

 

* depending on model

9

Page 11
Image 11
Rowenta DZ9030 manual Cleaning the iron, Problems?, Problems Cause Solution