Rowenta DZ9030 manual Descaling agents To the water in the water tank

None or too	Steam control set on dry		Turn the steam control to the
little steam is	position	.	required setting area.
being emitted.	Not enough water in the		Fill the water tank.
	water tank.
	Anti-Drip* is active		Wait for the soleplate to reach
	(§ 12).		the correct temperature.
The soleplate is	Residues in the steam		Use the Self Clean function then
dirty or brown	chamber or on the		clean your iron.
and can stain	soleplate.
the linen.	Use of chemical		Do not add any descaling agents
	descaling agents.		to the water in the water tank.
			Use the Self Clean function and
			clean your iron.
	Pure distilled/demine-		Only use untreated tap water or
	ralised or softened water		mix half tap water with half
	is being used.		distilled/demineralised water.
			Use the Self Clean function and
			clean your iron.
	Use of starch.		Always spray starch onto the
			reverse side of the fabric to be
			ironed and clean your iron
			soleplate.
Iron is leaking.	Soleplate temperature		Set the temperature control to a
	too low or overuse of		higher temperature and allow
	extra long shot of steam		more time between each shot.
	button.

If you are unable to trace the cause of the fault, contact an official Rowenta Customer Service Centre. The addresses are shown in the enclosed service centre address list. Helplines listed at the front of this leaflet.

Further hints and tips are obtainable from our homepage: www.rowenta.com.

Subject to modifications !

* depending on model 10