STEAM 'N PRESS TROUBLE SHOOTING
Problem | Possible Cause | Solution |
|
|
|
Leaking or | Distilled water. | Never use 100% distilled water. |
spitting. |
| The Steam 'n Press is designed to |
|
| use tap water. In very hard water |
|
| areas we recommend using |
|
| bottled spring water. |
| Softened water. | If you experience spitting or |
|
| leaking with softened water, |
|
| change to untreated tap water |
|
| or bottled spring water. |
| Thermostat set | The thermostat needs to be set |
| incorrectly. | to the 3 dot setting to produce |
|
| steam. |
| Overuse of burst | Allow 4 seconds between each |
| of steam. | burst. |
| Water tank. | Be sure that water tank is firmly |
|
| in place. |
| Isn't hot enough. | Allow Steam 'n Press to heat for |
|
| approximately 1 minute before |
|
| using. |
|
|
|
Steam 'n | Is it plugged in? | Check plug securely in socket. |
Press won't |
|
|
heat. | Is thermostat set | Turn the thermostat to a higher |
| too low? | setting. |
|
|
|
Does not | Is water in the | Ensure tank has water in it. |
steam. | tank? |
|
| Burst button not | Press the burst button |
| primed. | to begin steaming. |
|
|
|
Not enough | Dual voltage not | Be sure the dual voltage selector |
power or | set correctly. | is in correct voltage position |
too much |
| before operating. Unplug the |
|
| appliance and turn the selector |
|
| (which is below the handle) with |
|
| a coin to align it with the correct |
|
| voltage (either 120 or 240 V). |
|
|
|
11
