HOT Laminating Procedure

8.If the room temperature is low(under 64f), The ready light may take longer to come on.

9.Plug the laminator in after verifying the correct voltage. Failure to comply with the above information could result in serious injury.

1.Turn the power switch to the hot position.

The power indicator will light. Allow approximately 10 minutes to preheat. When the proper temperature is reached, the "ready" light will go on.

3.Insert the pouch film into the front opening of your laminator. Be sure to center the laminating pouch as it is inserted.

4.The item will autormatically feed out through the rear of the laminator.

(SAFETYNOTE: The laminated item may be too hot to touch.)

5.If the item is not completely laminated, repeat steps 3-5.

NOTE: Your finished laminated item will be hot,and will easily bend.

To keep your laminated item flat , place on flat surface and allow to cool.