Troubleshooting
1.Be sure the power cord is plugged into a working electrical outlet.
2.Check your room humidity level on display setting. The unit may simply be off because the humidity setting equals room humidity level. 3.Check for any obstructions.
Trouble |
| Cause |
| Solution | |
|
|
|
|
| |
| 1. | No power supply. | 1. | Plug power cord firmly into outlet and check fuse for that room. | |
| 2. | Turn the unit on. | |||
| 2. | Unit is not turned on. | |||
The unit does not work. | 3. | Set the humidity level on a lower percentage. | |||
3. | Humidity is set higher than the room humidity. | ||||
| 4. | If a unit was turned off and turned on automatically the | |||
| 4. | The power was shut off and automatically turned back on. | |||
|
| compressor will take 5 minutes to start. | |||
|
|
|
| ||
|
|
|
| ||
Water light is lit. | 1. | There is blockage of the flow of water in the unit. | 1. Check the hose for crimps or blockage. | ||
2. | The bucket is full of water. | 2. Make sure the water is emptied | |||
| |||||
|
|
|
|
| |
| 1. | Air filter is dirty and or blocked. | 1. | Clean the filter. | |
| 2. | Raise the room temperature. | |||
| 2. | The room temperature is below 5 °C (41 °F). | |||
The air in the room is still humid. | 3. | Improve the airflow by moving unit away from anything that | |||
3. | Poor air circulation or obstructions. | ||||
|
| obstructs the airflow. | |||
| 4. | Humidity is set higher than the room humidity. |
| ||
| 4. | Set the humidity percentage to a lower percentage. | |||
|
|
| |||
|
|
| |||
Relative humidity setting not being reached after | 1. There are windows or doors opened. | 1. Check to see the windows and doors are closed. | |||
a long period of operation. | 2. Area is too large for the capacity of the dehumidifier. | 2. Change the location of the dehumidifier | |||
|
|
| |||
On the Display (ES, AS, E1, P1 or P2) | These are error codes and protection codes | See the CONTROL PANEL section. | |||
|
|
|
|
|
13