Programming Control
Manual Programming Flowchart (1 of 3)
“dCYC” - Set the default cycle and
temperature.
“AUd” - Program when the signal will sound.
“E FL” - Fill Error
“E dr” - Drain Error
“E Ub” - Unbalance Error (VFD only)
“E oP” - Open Thermistor Error
(temp sensor only)
“E SH” - Shorted Thermistor Error
(temp sensor only)
“E Ht” - Heat Error (heater only)
“E Sd” - Slow Drain Detection
“AgIt” - Program the cycles agitation
action and speed
“LEr1” - Water Leak Detection During
a Machine Cycle
“LEr2” - Water Leak Detection - Day
of Week
“tyPE” - Agitation Type:
1 = 18/3/18
2 = 10/20/10
3 = 3/27/3
4 = 4/56/4
“ASPd” - Agitation Speed (VFD only):
“Lo” = Reduced Speed “rEg” = Normal Speed
“SEg1” - Program options for each segment. There are (8) segments available for programming
“FILL” - Program fill step options
“SgEn” - Segment Enabled/Disabled:
“on” = Enabled
“oFF” = Disabled
““FLEn” - Fill Step Enable/Disable:
“on” = Enabled
“oFF” = Disabled
“FLEU” - Fill Level: “HI” = High Level “nEd” = Medium Level “Lo” = Low Level
“tEnP” - Fill Temperature:
“CoLd” = Cold
“UArn” = Warm
“Hot” = Hot
(35˚F - 194˚F [2˚C - 90˚C])
(continued) | (continued) |
PHM128
PHM1280R
Figure 3
F8208801 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 15 |
