Alliance Laundry Systems PHM1263R manual Error Code Programming Err, LEr3, ESd

Programming Control

3.Error Code Programming “Err-”

This option allows the owner to turn on or turn off certain errors in the control.

How to Program Error Code Programming

1.Control must be in Manual Mode. Refer to Entering the Manual Mode.

2.Press the #3 (>) or the #6 (<) keypad until

“Prog” appears in the display. Press the START (enter) keypad and “dCYC” will appear in the display.

3.Press the #3 (>) or the #6 (<) keypad to scroll through the programmable options until “Err-” appears in the display.

4.When “Err-” appears in the display, press the START (enter) keypad. Refer to Table 3 for a list of programmable error code parameters.

5.Press the #3 (>) or the #6 (<) keypad to select error code.

6.Press the START (enter) keypad when the correct code appears in the display. The current status will appear in the display.

“on” = Error Code Enabled “oFF” = Error Code Disabled

7.Press the #3 (>) or the #6 (<) keypad to change the status.

8.Press the START (enter) keypad when the correct status appears in the display. The next Error Code Programming option will appear in the display.

NOTE: To program “Cy--”(Cycle Programming), press the #5 (<) keypad, then the #3 (>) keypad and refer to option 4. To program other options, refer to the appropriate section.

How to Exit Programming Feature

9.Press the #5 (<) keypad until the control returns to Start Mode.

“E FL”	Fill Error
“E dr”	Drain Error
“E Ub”	Unbalance Error Display (VFD only)
“E oP”	Open Thermistor Error Display
“E SH”	Shorted Thermistor Error Display
“E Ht”	Heat Error Display (Heater only)
“LEr-”	Leak Detection Error
	If water leak detection during a machine
	cycle is enabled, then, on the enabled day(s)
	of the week, the control will check for water
	leaks during running machine cycles. If a
	leak is detected, the control will display the
	“E Ld” error for one minute after the cycle
	is completed. It will also light the right-most
	decimal point on the display. To turn off the
	right-most decimal point on the display,
	press the START keypad 3 times (within 5
	seconds) anytime after the first fill. The
	water leak detector diagnostic test can be
	used to verify the leak.
			Water Leak Detection During
	“LEr1”		a Machine Cycle - Determines
			if water level drops below
			target level.
			Water Leak Detection During
			Machine Cycle Day of Week
	“LEr2”		Enable (Refer to Figure 3 for
			Day(s) of the Week Enabled
			Values)
			Number of Cycles Between
			Water Leak Detection During
	“LEr3”		a Machine Cycle (Option not
			available on Software
			Version 1.)
“ESd”	Slow Drain Detection Determines if
	machine is draining slower than normal.
	If Slow Drain Detection is enabled, the
	control will check for slow drain operation
	during running machine cycles. If a slow
	drain is detected, the control will display the
	“ESd” error for one minute after the cycle is
	completed. It will also light the right-most
	decimal point on the display. For machines
	equipped with Software Version 2, to turn
	off the right-most decimal point on the
	display, press the START keypad 3 times
	(within 5 seconds) anytime after the first fill.
		Table 3

22 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F8208801