Washer-Extractor Operation
Start Up
When power is applied to the
Door Locking Mode
The control enters this mode after the START (enter) keypad is pressed in Start Mode. The control stays in Door Locking Mode until it confirms the door is closed and locked.
Stop Mode
The control enters this mode if the user stops the cycle by pressing the STOP keypad. If control does not detect water or cylinder rotation it will enter End Of Cycle mode.
Start Mode
The control enters this mode when machine is ready for operation. The display will show “CYxx” where “xx” is the cycle number.
After pressing the START keypad, with the door closed and locked, the cycle will begin. The cycle cannot be changed once the cycle has started.
End of Cycle Mode
When a cycle is complete, the control will display “00” and will prompt for door unlock by flashing STOP/ UNLOCK LED until the washer door is unlocked and opened. When this event occurs, the display will revert back to Start Mode.
Cycle Sequence
Upon the start of a cycle, the control will display the total cycle time. The appropriate LEDs will light while the machine passes through different cycle steps. The user will not be able to change cycles or water temperature.
Run Mode
The control enters this mode when a cycle is running. The time remaining appears in the display, the status LED’s are lit and the loading door is locked.
Signals
There are two options when a signal can be used during the washer operation. These two options are listed below:
1.End of Cycle Signal
By default, this signal is turned off. If turned on, the signal sounds for three (3) seconds at the end of a cycle.
2.Signal On Keypad Depression
By default, this signal is turned on and sounds for a quarter of a second each time a keypad is pressed.
NOTE: Refer to Programming Control to program signal options.
8 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F8208801 |
