Alliance Laundry Systems PHM1263R manual Error Codes

Error Codes

Following is a list of possible error codes for an electronic control. Errors beginning with “EI” refer to external device Infra-red communication errors. All other errors refer to machine errors.

Display	Description		Cause/
			Corrective Action
EI01	Transmission Failure		Communication failure. Re-aim external device and try again.
EI02	Time-out Error		Communication failure. Re-aim external device and try again.
EI03	Invalid Command Code		Communication successful, but the command was not valid
			for this machine type, or the control could not perform the
			command in its current mode of operation. Ensure data is for
			current machine type and control is in correct mode.
EI04	Expecting Upload Request		Communication failure. Re-aim external device and try again.
EI05	Invalid or Out-of-Range Data		The value in at least one of the programming options is
			invalid or out of range. Recheck the programming option’s
			value and try again.
EI09	CRC-16 Error		Communication failure. Re-aim external device and try again.
EI0A	Framing Error		Communication error. Re-aim external device and try again.
EI0C	Time-out Exceeded		Communication error. Re-aim external device and try again.
EI0E	Encryption Error		Communication error. Re-aim external device and try again.
			If the problem persists, check that the security code is correct.
EI0F	Infra-red Disabled		Communication failure or infra-red is disabled. Manually
			enable infra-red on control or re-aim external device and try
			again.
E FL	Fill Error		Programmed water level not reached within 10 minutes (or
			other programmed length of time) in any fill agitate cycle.
			End cycle. Power down machine to clear.
E SP	SPI Communications Error		Front End control cannot communicate with output board.
			Power down the machine, power up and try again.
		Table 16 (continued)

F8208801 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 51