14. No Cycle Time Display “nCtd”
This option allows the owner to enable or disable whether the cycle time will appear in the display.
How to Program in the Cycle Time Display
1.Control must be in Manual Mode. Refer to Entering the Manual Mode.
2.Press the #3 (>) or the #6 (<) keypad until
“Prog” appears in the display. Press the START (enter) keypad and “dCyC” will appear in the display.
3.Press the #3 (>) or the #6 (<) keypad to scroll through the programmable options until “nCtd” appears in the display.
4.When “nCtd” appears in the display, press the START (enter) keypad. The current No Cycle Time Display status will appear in the display. “on” = Option Enabled
“oFF” = Option Disabled
5.Press the #3 (>) or the #6 (<) keypad to change the current status.
6.Press the START (enter) keypad when the desired status appears in the display. The next option, “PCtd” will appear in the display.
NOTE: To program “PCtd” (Programmable Cycle Time Display), refer to option 15. To program other options, refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to Start Mode.
Programming Control
15.Programmable Cycle Time Display “PCtd”
NOTE: This option is available on Software Version 2 only.
This option allows the owner to display either the normal remaining cycle time or the programmed time during a machine cycle.
How to Program the Programmable Cycle Time Display
1.Control must be in Manual Mode. Refer to Entering the Manual Mode.
2.Press the #3 (>) or the #6 (<) keypad until
“Prog” appears in the display. Press the START (enter) keypad and “dCyC” will appear in the display.
3.Press the #3 (>) or the #6 (<) keypad to scroll through the programmable options until “PCtd” appears in the display.
4.When “PCtd” appears in the display, press the START (enter) keypad. The current Programmable Cycle Time Display status will appear in the display.
“0” = Option Disabled “1” = Option Enabled
5.Press the #3 (>) or the #6 (<) keypad to change the current status.
6.Press the START (enter) keypad when the desired status appears in the display. The next option, “SdAd”, will appear in the display.
NOTE: To program “SdAd” (Slow Drain Detection Adjust), refer to option 16. To program other options, refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to Start Mode.
F8208801 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 35 |
