13.INSTALLATION OF FRONT FEEDER and REAR REWINDER OPTIONS
Note: Below options are to be installed by an authorized RS reseller.
Installation of the Front Feeder Option (Includes 2 brackets, one spindle, and mounting hardware).
1.Install the Front Feeder to the inside of the front frames using four 1/4"(M6) hexagon bolts on each side (Figure 1)
RSC Series
4.Disassemble the power switch bracket and place the left rewinder outside of the frame; fasten with round head 3/16"(M5) screws (included in the option kit). Then, reinstall the power switch bracket (Figure 7).
Figure 7
5.Install the right rewinder on the outside of the frame and connect the motor wire connector to the rear wire (Figure 8 & 9).
Installing the Rear Rewinder Option (Includes motorized winder, bracket, one spindle, and mounting hardware).
1.Remove the left and right covers by using a Phillips screwdriver (four screws on each side cover) (Figure 2 & 3).
Figure 1
Figure 2 | Figure 3 |
6. Reinstall the rear cover.
7. Reinstall the side covers.
8. Reinstall the lever knob and screw.
Figure 8
Figure 9
2. Remove the lever knob screw and lever (Figure 4).
Figure 4
3.Remove the rear cover by removing all 10 screws (4 top, 4 bottom, and 1 on each side) (Figure 5 & 6).
Figure 5 | Figure 6 |
