17.Press the Stop button when the leader board has completely exited from the rollers.
18.Use the Cross Cutter to cut the leader board from the web (see page 9).
19.Set the nip setting to the appropriate position for the
12.2.Mounting
1.Lay the decaled image face down on a flat surface. Carefully peel back and put a crease along the edge of the release liner ( Approximately 1 in or 25mm, Figure 1).
Figure 1
2.With the image facing up, align the image onto the board. Press firmly from the center out (Figure 2).
Figure 2
3.Adjust the pressure lever to ensure the proper opening (Figure 3).
Figure 3
4.Flip the image over the top roller and hold on to the release liner (Figure 4).
5.Press the foot pedal once, and then let it go while slowly pulling the release liner as the board enters the main roller nip (Figure 5)
6. Press the foot pedal once again when the board has completely exited from the rear of the unit. Trim the board if necessary.
RSC Series
Figure 4
Figure 5
13 | 14 |
