10. USING CROSS CUTTER
The cross cutter is located on the rear exit table of the machine.
1. After lamination, move the cutter approximately to the center of the completed application at the desired point of detachment (Figure 1).
Figure 1
2. Grasp film with one hand, press the cutter downward into the application and slide it first to one end of the application, then to the other end to complete the cut (Figure 2 & 3).
Figure 2
Figure 3
9
RSC Series
11. LOADING FILM
Royal Sovereign films are wound with the adhesive side facing the inside of the roll (adhesive in).
Loading films to the top and bottom film shafts: (See page 5 for assistance with parts identification.)
1.Remove the top and bottom film shafts from the machine.
Figure 1
2.Load a roll of pressure sensitive film to the top film shaft (Figure 1). Center the film and tighten the core screws (Figure 2).
3. Load a roll of mounting film or roll of craft paper to the | Figure 2 |
bottom film shaft. Do not tighten the core screws at |
|
this time.(Figure 3) |
|
Note: Please see the direction of the film on the top |
|
and bottom shafts. |
|
4. Load the top and bottom film shafts onto the machine | Figure 3 |
(Figure 4 & 5). |
|
Figure 4 | Figure 5 |
10
