17 | Set the Left Door Panel (AK) face down on the ground. |
| Starting at the top of the door, slide the Door Reinforcement (NN) onto the groove located | |
Slide the Hinge Reinforcement (PP) into the hole on the top door pin. The Hinge | on the handle side of the door. The Door Reinforcement (NN) will slide to the stop at the | |||
Reinforcement (PP) will slide in until it is below the end of the door pin. |
| 18 bottom of the door. | ||
|
|
|
| AK |
| PP | AK | AK | AK |
|
|
|
| NN |
NN
AK | AK |
PP
NN
19 | Install the Gasket (MM) into the gasket groove in the door. Start at the top and middle, by | Install the Window (LL) onto the door by matching up the holes and installing the Screws |
pushing the gasket into the groove. Continue until the Gasket (MM) is fully installed. | (KK) and Washers (TT) 15 places. The “frosted” side of the window should be touching | |
There will be a small gap between the ends of the gasket. | the gasket. Install screws in order starting at position 1. | |
| 20 Repeat steps | |
|
| KK (15) |
MM | TT (15) | |
TT |
KK |
AK |
MM |
|
| 4 |
14 | 15 | 3 | |
Start |
|
|
|
13 | 1 | LL | 2 | 5 |
12 | 11 | 10 | 9 | 8 | 7 | 6 |
|
|
| ||||
|
|
|
|
| ||
|
|
|
|
|
|
AK |
Caution: Tighten screws only enough to compress gasket.
