Ruckus MF2900 Quick Setup Guide
Find the Ruckus MF2900 AP over your wireless network
You should now be able to find the SSID of your MF2900 AP over your wireless network. If you have changed the default Network Name (SSID), or the security settings, make sure your PC and other devices in your wireless network use the same security settings as the Ruckus MF2900 AP.
Troubleshooting
Listed below are some things to check if you cannot connect to your MF2900 AP.
Startup sequence
1.Unplug the MF2900 AP’s power supply.
2.Plug in the MF2900 AP’s power supply.
3.Connect the MF2900 AP to your home router or gateway.
4.From your PC, find the MF2900 AP’s SSID on the wireless network, then Connect.
Log into the Ruckus MF2900 AP to verify the wireless settings
If the startup sequence didn’t work, verify that the Net- work name (SSID) and security settings on the MF2900 AP match that of your wireless network.
1.Connect your computer to the MF2900 Multimedia access point by an Ethernet cable. Set your comput- er’s network to an IP address within the same range as the MF2900 AP’s default IP address.
2.Open a Web browser window.
3.Point your browser to http://192.168.0.1. At the login screen, enter the username admin and leave password field blank. Click the Login button.
4.Click the System link under he Configuration menu on the left panel of the Ruckus Web user interface. Verify that your computer’s wireless network settings match that of the Ruckus MF2900 AP.
Check the LED status lights to verify correct operation
1.Make sure you are using the power adapter sup- plied by Ruckus Wireless, Inc.
2.Make sure the Power LED is lit. If it is not lit, make sure that the power cord is properly connected to the MF2900 AP, and that the power supply adapter is properly connected to a functioning power outlet. If the error persists, you have a hardware problem and should contact technical support.
3.Make sure your LAN link LED is lit. Make sure that the Ethernet cable connections are secure at the MF2900 AP and your computer. The LAN LED on the MF2900 AP indicates link when the adapter is fully seated in the port.
4.Make sure the Wireless LED is either steady or flashing Green. If not lit, the Wireless settings may be incorrect between the MF2900 AP and your computer.
If necessary, reset the Ruckus MF2900 AP to its factory defaults
If you forgot what IP address or security settings you assigned to the MF2900 AP, you can reset it to factory defaults by inserting the end of a paper clip into the reset button hole located on the back of the unit. Press and hold the reset button for at least four seconds, un- til all antenna LEDs start to flash simultaneously. Then you can connect to the MF2900 AP using the default network settings.
8000006
