Runco virtual high definition processor with aspect ratio control, VHD-4402 manual Front Panel

FRONT AND REAR PANEL DESCRIPTIONS

Front Panel

1	2
							enu
						M
4402 ULTRA
	RUNCO
	M U LT I F I L M
	3	4	5	6	7	8	9

1.IR RECEIVER

Receives the IR commands from the remote control.

2.MENU BUTTON

The MENU button brings up the main adjustment menu. After making adjustments, the MENU button will bring you back to the sub-menu, then the main menu. The Menu will then either time-out after approximately 10 sec- onds, or pressing the MENU button will remove the menu immediately.

3.LCD DISPLAY

Indicates the function or active adjustments and current scan rate.

4.UP BUTTON

When no menu is present on-screen, this button will toggle you through the different aspect ratios. When the menu is on-screen, the up button will move the cursor up within a menu.

5.LEFT BUTTON

When no menu is present on-screen, this button will toggle you through the four different sources, in the order of:

COMPOSITES-VIDEOCOMPONENTPASS THROUGH

When an adjustment function has been selected (i.e. Brightness), the LEFT button will decrease the value of that function.

6.ENTER BUTTON

When an item is highlighted on the On-Screen Display, the ENTER button will select the item.

7.DOWN BUTTON

When no menu is present on-screen, this button will toggle you through the different aspect ratios. When the menu is on-screen, the down button will move the cursor down within a menu.

8.RIGHT BUTTON

When no menu is present on-screen, this button will toggle you through the four different sources, in the order of:

PASS THROUGH COMPONENTS-VIDEOCOMPOSITE

When an adjustment function has been selected (i.e. Brightness), the RIGHT button will increase the value of that function.

9.POWER BUTTON

Turns the unit on. The MAIN POWER switch on the rear of the unit must be on first for this button to be active.

7