Runco VX-33I - page 6

vi Runco VX-33i Installation/Operation Manual

PRELIMINARY

RUNCO’S MAXIMUM AGGREGATE LIABILITY HEREUNDER IS LIMITED TO THE COST OF REPAIR OR REPLACEMENT OF

THE PRODUCT.

1. RUNCO SHALL NOT BE LIABLE FOR DAMAGE TO OTHER PROPERTY CAUSED BY ANY DEFECT IN THE PRODUCT,

DAMAGES BASED UPON INCONVENIENCE, LOSS OF USE OF THE PRODUCT, LOSS OF TIME, LOSS OF PROFITS,

LOSS OF BUSINESS OPPORTUNITY, LOSS OF GOODWILL, INTERFERENCE WITH BUSINESS RELATIONSHIPS, OR

OTHER COMMERCIAL LOSS, EVEN IF THE CUSTOMER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

2. RUNCO SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, INDIRECT, SPECIAL, OR PUNITIVE

DAMAGES ANY OTHER DAMAGES, WHETHER INCIDENTAL, INDIRECT, CONSEQUENTIAL OR OTHERWISE.

3. RUNCO SHALL NOT BE LIABLE FOR ANY CLAIM AGAINST THE CUSTOMER BY ANY OTHER PARTY.

This warranty gives you specific legal rights, and you may have other rights, which vary from locality to locality. Some localities

do not allow limitations on implied warranties and/or do not allow the exclusion of incidental or consequential damages, so the

above limitations and exclusions may not apply to you.

© Copyright 2009 Runco International, LLC (“Runco”). This document contains proprietary information protected by copyright,

trademark and other intellectual property laws. All rights are reserved. No part of this manual may be reproduced by any

mechanical, electronic or other means, in any form, without prior written permission of Runco.

The trademarks reporduced in this Runco Owner’s Manual and used on the Runco Products are either owned by Runco or are

licensed by Runco. You may not reproduce or use the trademarks without the prior written consent of Runco.

THX and the THX logo are trademarks of THX Ltd. which may be registered in some jurisdictions. All rights reserved.

Runco Products are manufactured under one or more of the following patents: US. Patent 6755540 and Other Patents

Pending.

Exclusion of Damages

Effect of Local Law

COPYRIGHT AND TRADEMARKS:

Contents

Main Page RuncoCare Standard Two Year Limited Warranty Page Page Page Important Safety Instructions Compliance Information Page Page Page Page Page Page Page Page 1.1 About This Manual 1. Introduction 1.2 Using This Manual WARNING DANGER! 1.3 Description, Features and Benefits Page 2.1 VX-33i at a Glance 2. Controls and Functions 2.2 VX-33i Rear Panel Page 2.3 VX-33i Rear Connector Panel Page 10 Runco VX-33i Installation/Operation Manual 2.4 VX-33i Remote Control Figure 2-4. VX-33i Remote Control LIGHT OFF ON SOURCE PICTURE MEMORY ASPECT RATIO Page Page 3. Installation 3.1 Remote Control 3.2 Quick Setup Table 3-1. Installation Overview 3.3 Installation Considerations Table 3-2. Projector Installation Options Table 3-3. VX-33i Lens Options and Throw Ratios Ceiling Installation Floor Installation Figure 3-4. Horizontal Lens Shift (EXAMPLE ONLY) Table 3-4. VX-33i Vertical and Horizontal Lens Shift Limits 3.4 Installing the Primary Projection Lens Page 3.5 Installing the Optional CineWide Lens Mount Page Page Page Page 3.6 Mounting the VX-33i 3.7 Connections to the VX-33i Runco VX-33i Installation/Operation Manual 29 Digital (DTV) RGB or Component Video Connections: See Figure 3-11 and Figure 3-12. Figure 3-11. Digital (DTV) RGB or Component Video Connections (HD1, HD2) Page Page Page to Automation/ Control System or PC Page Page 3.8 Turning on the Power 3.9 Adjusting the Picture Orientation VX33i Component RCA 16:9 480I 3.10 Primary Lens Adjustments 3.11 Installing and Adjusting the CineWide Anamorphic Lens Page Page Page Page Wrong Position Correct Position Page 4. Operation Figure 4-1. VX-33i OSD Menu Structure Input Source Calibration Memory Presets Input Position 7 Table 4-1. Aspect Ratio Settings Table 4-1. Aspect Ratio Settings (continued) Page Page Page Page 7 Page Page Page Page 5.1 Lamp Replacement 5. Maintenance and Troubleshooting WARNING 5.2 Filter Replacement Side Filter Access Panel 5.3 Troubleshooting Tips Table 5-1. Troubleshooting Chart Page 6. Serial Communications 6.1 RS-232 Connection and Port Configuration 6.2 Serial Command Syntax Table 6-1. Serial Commands and Responses Page STATUS 1 STATUS 2 STATUS 3 STATUS 4 STATUS 5 STATUS 10 STATUS Page 7.1 VX-33i Specifications Table 7-1 lists the VX-33i specifications. 7. Specifications Table 7-1. VX-33i Specifications Table 7-1. VX-33i Specifications (continued) Runco VX-33i Installation/Operation Manual 71 7.2 VX-33i Dimensions Figure 7-1 shows the VX-33i dimensions (all dimensions are in inches). Figure 7-1. VX-33i/CineWide with AutoScope Dimensions 7.3 Supported Timings Table 7-2 lists the signal types supported by each input on the VX-33i. Table 7-2. Supported Signal Timings by Input Table 7-2. Supported Signal Timings by Input (continued)